LED Automatic Mounting Rack
May 05, 2021
Automatic mounting is actually a combination of the two steps of glue dip (glue) and chip mounting. First, silver glue (insulating glue) is applied on the LED bracket, and then the LED chip is sucked up to the moving position with a vacuum nozzle, and then placed in the The corresponding bracket position.
In the process of automatic racking, it is mainly necessary to be familiar with the equipment operation programming, and at the same time adjust the glue and installation accuracy of the equipment. In the selection of nozzles, try to use bakelite nozzles to prevent damage to the surface of the LED chip, especially bakelite must be used for blue and green chips. Because the steel nozzle will scratch the current diffusion layer on the surface of the chip.
